| InfiSense
Your critical equipment are covered. What about everything else?
Most plants have prescriptive AI on critical assets. The pumps, motors, blowers, and conveyors around them get nothing - until they fail. InfiSense changes that. No wiring. No gateway. No battery changes. Mounts in minutes.
Book a Discovery Call
Connecting to HubSpot Booking System...
Secondary equipment fail silently.
Balance-of-plant assets are too numerous to wire up, too spread out for manual rounds, and too expensive to ignore when they stop a line.
Too many assets to instrument
Traditional wired sensors require infrastructure. Most plants leave hundreds of secondary assets completely unmonitored.
Manual rounds don't catch faults
Route-based checks are periodic and subjective. Faults develop between rounds and surface only when equipment stops.
Battery sensors die or go dark
Battery-operated sensors wake a few times a day, require replacement cycles, and stop working when you need them most.
Data without action is noise
Raw vibration charts require specialists to interpret. Maintenance managers need prescriptions - not graphs to decode.
Built for plant-wide deployment.
Energy harvesting - no batteries, ever
Powered by ambient light. Works indoors and outdoors. No battery replacements. No charging cycles.
Built-in cellular - no gateway needed
NB-IoT or LTE-Cat M built in. Works wherever there's cellular coverage. Zero network infrastructure required.
IP65 standard + ATEX Zone 0 for hazardous areas
Standard IP65 for F&B lines. ATEX Zone 0 Ex-certified version for hazardous chemical zones.
Failure modes detected
Unbalance, misalignment, bearing defects, gear defects, structural looseness, rotating looseness, pump flow issues, and more.
Already running a sensor program?
Here's what's different.
Built for the plants where downtime hits hardest.
Food & Beverage
One failed pump stops the entire run.
Chemicals
ATEX Zone 0-certified for hazardous zones.
